Table of Contents
Advertisement
Bulb Replacement
Withdraw the front rim after removing the securing screw. Press in the lamp unit
against the tension of the three adjusting screw springs and turn in an anti-clockwise
direction until the key-slot holes in the rim line up with the screw heads. The lamp
unit can then be drawn off. Do not rotate any of the screws as this will affect the
alignment of the reflector when assembled.
Rotate the back shell anti-clockwise and pull off, then the head lamp bulb can be
removed. Care should be taken to see that the bulb does not drop out.
Parking Lamps (Front)
(Lucas No. 989, 12 volt 6 watt single contact bulbs fitted.) To remove bulb, peel
back the rubber ring and remove rim, then the bulb can be withdrawn. When
replacing rim, first slip the edge over the two small lugs, then peel back rubber as
rim is fitted. Ensure that the rubber is located correctly over the rim edge, otherwise
vibration may cause the rim to become detached.
ELECTRICAL SYSTEM—Lamps
62
Advertisement
Table of Contents
