Sony ExwaveHAD DXC-390 Instructions For Use Manual page 28

Adjusting and Setting with Menus
Setting item Contents of setting
(VBS lock) Adjusts the horizontal phase and SC
H. PHASE* (subcarrier) phase during external
SC. PHASE synchronization (with VBS signal input).
ROUGH*
SC. PHASE
FINE*
(HD/VD lock) Adjusts the horizontal phase during
H. PHASE* external synchronization (with HD/VD
signal input).
* Displayed only when an external sync signal is input.
BAUD RATE
Switches the baud rate of the REMOTE
rear panel.
Sets to any of 19200, 9600, 4800, 2400 and 1200.
Normally, set to 9600 when the RM-C950 remote control
unit is connected to the REMOTE
28
(GB) Chapter 2 Operation
D-SUB VIDEO
Ref. page
Switches the video signal output from the
29
connector (D-sub 9-pin) at the rear panel.
29
D-SUB SYNC
Switches the sync signal output from the
connector (D-sub 9-pin) at the rear panel.
connector at the
connector.
Selection Function
VBS Outputs VBS signal.
Y/C Outputs Y/C signal.
Selection Function
C.SYNC Outputs the composite sync signal.
WEN Outputs the WEN signal. When connecting peripheral
equipment, the signal is used as trigger pulse output to
the equipment.
Select the polarity of the WEN signal with the POLARITY
setting.
: Negative
: Positive
RGB/SYNC
RGB/SYNC