Sony ExwaveHAD DXC-390 Instructions For Use Manual page 27

TRIGGER
Set when you use a slave unit connected to the TRIG IN
connector and synchronize the camera with a stroboscope.
Selection Function
OFF Select when you do not connect a slave unit.
ON Select when you connect a slave unit.
Select POLARITY, and set it to the same polarity as the
input pulse signal.
: Falling edge
: Rising edge
NEGA
Reverses the output image to negative/positive.
Selection Function
OFF Outputs the image normally.
ON Outputs the image reversed to negative/positive.
FLICKER CANCELLER
When using the camera in a 50 Hz lighting area, you can
obtain images with less flicker under fluorescent light even
when SHUTTER is set to CCD IRIS or OFF. Set this item to
OFF when you want to set NEGA to ON.
Selection Function
OFF Disables the FLICKER CANCELLER function.
ON Reduces flicker.
SYSTEM menu
Sets the items relating to the system of the camera and
selection of output signals.
<SYSTEM>
>BAUD RATE
D-SUB VIDEO
D-SUB SYNC
RGB SYNC
12P CONNECTOR
Select
Setting items in the SYSTEM menu
Setting item Contents of setting
BAUD RATE Selects the baud rate.
D-SUB VIDEO Switches the video signal output from
the RGB/SYNC connector (D-sub
9-pin).
D-SUB SYNC Switches the sync signal output from the
RGB/SYNC connector (D-sub 9-pin).
RGB SYNC Adds a sync signal to the RGB output.
12P Switches the input and output of the
CONNECTOR DC IN/VBS connector and selects the
output signal.
[A]
9600
VBS
C.SYNC
G
IN
Back
MENU
Ref. page
28
28
28
29
29
(Continued)
27
Chapter 2 Operation (GB)