Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS
13. USE THE RIGHT TOOL. Don't force a small tool or attachment to do the work
of a larger industrial tool. Don't use a tool for a purpose for which it was not
intended.
14. DRESS PROPERLY. Don't wear loose clothing or jewelry; they can be caught
in moving parts. Protective, non-electrically conductive gloves and non-skid
footwear are recommended when working. Wear protective hair covering to
contain long hair and keep it from harm.
15. USE EYE PROTECTION. Use a full-face mask if the work you're doing produc
16. SECURE WORK. Use clamps or a vise to hold the work. It's safer than using
17. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
19. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
22. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY AD-
23. STAY ALERT. Watch what you are doing & use common sense. Don't operate
24. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is dam-
25. REPLACEMENT PARTS. When servicing, use only identical replacement parts.
26. SERVICE AND REPAIRS should be made by qualified repair technicians at an
SAFETY PRECAUTIONS
ALWAYS CHECK THE SPEED RATING OF ACCESSORIES. This tool will spin
!
accessories at up to
very likely fly apart and could cause serious injury.
es metal filings, dust or wood chips. Goggles are acceptable in other situations.
Wear a clean dust mask if the work involves creating a lot of fine or coarse
dust.
your hands and it frees both hands to operate the tool.
reach over or across machines that are running.
safer performance. Follow instructions for lubricating and changing accessories.
For safe performance, keep handles dry, clean and free from oil and grease.
before plugging in.
OR WRENCHES before turning the tool on. Left attached, these parts can fly
off a rotating part and result in personal injury.
your tool repaired before using it.
JUSTMENTS. Changing attachments or accessories can be dangerous if the
tool could accidentally start.
any tool when you are tired.
aged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any ones that are loose. Any
part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service center. Don't use
the tool if switch does not turn it on and off properly.
authorized repair centre. Improperly repaired tools could cause serious shock
or injury
1400
rpm. Accessories not rated for speeds this high will
Advertisement
Table of Contents
