Advertisement
在接头(2)的G1/2"螺纹上缠绕足以密封
的 密 封 胶 带 或 涂 合 适 的 密 封 胶 。 用
8mm六角扳手将接头旋紧到G1/2"内螺
纹 管 道 配 件 上 ， 且 使 其 低 于 墙 面
2~12mm。用螺钉(3)将底座(4)装到接
头上，使底座紧贴墙面，且两凸起(5)
水平。将接头组件(6)装入底座。将托
架组件(7)套在接头组件上，紧贴墙壁
且保持两个螺孔铅垂向下。用六角扳
手(8)锁紧螺钉(9)，固定托架组件。
去掉软管(10)两端接头的保护套。用软
管连接接头(11)。
清洗说明
适用于所有加工处理过的表面：以中性肥皂水清洗
镀层表面，再以干净的软布彻底擦干整个表面，许
多清洁剂，比如氨水、去污粉及洁厕灵等，会对电
镀表面造成伤害，切忌使用。
有磨损性的清洁用具或清洁剂也不可使用于科勒牌
的水龙头及其配件上。
零件图
1046290
Hex Wrench
六角扳手
**订购时请说明颜色编号
**Color code must be specified when ordering
1170832-2-C
11
10
1156389
Connector
1156391
接头
Fixed Board
底座
870817
O-ring
835157
O型圈
Screw
1156388
螺钉
Connector
接头
871527
O-ring
O型圈
1177979
Screw
螺钉
1
5
2
4
3
6
7
8
9
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals, such
as ammonia, chlorine, toilet cleaner etc. which could
adversely affect the finish and are not recommended
for cleaning.
Do not use abrasive cleaners or solvents on Kohler
faucets and fittings.
SERVICE PARTS
Apply tape or thread sealant to G1/2"
threads of the connector(2). Tighten the
connector onto the G1/2" female supply
fitting, and below the finished wall
2~12mm. Install the fixed board(4) onto
the connector with the screws(3) so that
the fixed board is against the finished
wall, and keep two bulges(5)
horizontally. Install the connector(6) into
the fixed board. Slide the bracket kit(7)
onto the connector kit against the
finished wall, and keep two screw holes
downwards. Tighten the screws(9) with
the hex wrench(8) to secure the bracket
kit.
Remove the guards on the outlet
connectors of the hose(10). Connect
the connector(11) with the hose.
1248781**
Hose
软管
2
Advertisement
