Advertisement
安装说明
在G1/2˝接管(1，客户自备)两端螺纹
上缠绕足以密封的密封胶带或涂合适
的密封膏。安装G1/2˝接管，接管露出
墙外9~13mm。
打开水源，冲水约一分钟，以清除杂
质。
将装饰罩(2)旋到花洒臂组件(3)上。用
带状扳手将花洒臂组件拧到G1/2˝接管
上，调整花洒臂到合适位置拧紧。
维护与保养
使用一段时间后，如发现花洒臂有自
降的倾向，可以通过旋紧螺母(5)来紧
固。方法如下：用手把压盖(4)取下，
用产品中配带的扳手(6)顺时针紧固螺
4
母(5)。然后再把压盖装好。
安装结果检查
检查并确保所有衔接处都已拧紧。打开主水源，检
查并修理有漏水的接口。
清洗说明
适用于所有加工处理过的表面：以中性肥皂水清洗
镀层表面，再以干净的软布彻底擦干整个表面，许
多清洁剂，比如氨水、去污粉及洁厕灵等，会对电
镀表面造成伤害，切忌使用。
有磨损性的清洁用具或清洁剂也不可使用于科勒牌
的水龙头及其配件上。
1184923-2-C
INSTALLATION
Apply tape or sealant to the G1/2
nipple(1, not provided) threads. Install
˝ nipple and make it extend
the G1/2
9~13mm beyond the finished wall.
Flush water supplies through the
1
shower arm for about one minute to
2
3
remove debris.
Screw the escutcheon(2) onto the
shower arm kit(3). Thread the shower
arm kit to the G1/2
˝ nipple. Adjust the
shower arm to the appropriate
position, tighten it by strap wrench.
CARE AND MAINTENANCE
If found the arm dropped after a long
time, you can tighten it by the screws
(5). Remove the plugs(4) by hand.
Tighten the screws(5) clockwise by the
6
wrench(6) provided. Reinstall the plugs.
5
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight. Turn on the
main water supply, and check for leaks. Repair as
need.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with a mild soap and
warm water. Wipe entire surface completely dry with
clean soft cloth. Many cleaners may contain
chemicals, such as ammonia, chlorine, toilet cleaner
etc. which could adversely affect the finish and are not
recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler
faucets and fittings.
˝
SERVICE PARTS
零 件 图
**订购时请说明颜色编号
**Color code must be specified when ordering
2
1184923-2-C
15704T
花洒臂
1179564**
Escutcheon
装饰罩
Articulating Shower Arm
3
Advertisement
