lap Napoli 108PG Instruction Leaflet

Commissioning

• Ensure that the screws and cable entry points are
sealed to maintain the IP rating of the product.
• Refit the shade and outer bezel and secure with the
screws. Ensure the seals are correctly located.

Fitting/replacing bulbs

• Fitting/Replacing the bulbs - 1 x MAX 40W E27 GLS.
Suitable for use with LED bulbs.
• Do not exceed specified wattage (marked on product)
as this may cause the product to overheat. Always
switch off and allow product to cool before changing
the bulb.

Cleaning

We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.

Recycling advice

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice. The packaging on this product can also be recycled.

Safety information

For your safety, always switch off the supply before changing lightbulbs, or cleaning.
The glass shade must be replaced if it becomes cracked or damaged.
Do not use product without glass shade attached.
UK Manufacturer:
Kingfisher International Products Limited,
3 Sheldon Square, London, W2 6PX,
United Kingdom.
• Replace fuse or circuit breaker and switch on.
Your light is now ready for use.
• Unscrew the shade and remove.
• Remove the old bulb and replace with a bulb of the
same type and wattage.
• Replace the shade making sure the seal is properly
seated.
Glass parts – Wipe clean with a damp cloth. Do not use
abrasive materials as these will damage the finish.
Replace Cracked
Shade
EU Manufacturer:
Kingfisher International Products B.V.
Rapenburgerstraat 175E,
1011 VM Amsterdam, The Netherlands.
Instruction leaflet
Napoli Round Bulkhead
Napoli Caged Bulkhead
Outdoor Wall Light
108PG, 589PG
24/05/2021