Download Print this page
lap 172PG Instruction Leaflet

lap 172PG Instruction Leaflet

Half lantern pir outdoor wall light

Advertisement

Quick Links

PIR Adjustment
The unit must be installed in a vertical position, and fitted
1-2m above the ground. The PIR sensor can be adjusted
using the SENS and TIME dials.
The detection angle is set at 105 degrees. The maximum
detection distance is 8m.
Max. 8M
Fitting/replacing bulbs
• Fitting/Replacing the bulbs - MAX 15W LED E27 GLS.
• When changing a bulb, always, switch off at the
mains and allow the bulb to cool before handling.
Dispose of used bulbs carefully. Do not exceed the
wattage stated or use a different shape bulb from
that indicated on the fitting.
Cleaning
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice. The packaging on this product can also be recycled.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
The glass shade must be replaced if it becomes cracked or damaged.
Do not use product without glass shade attached.
UK Manufacturer:
Kingfisher International Products Limited,
3 Sheldon Square, London, W2 6PX,
United Kingdom.
The length of time that the light is on can be adjusted
by turning the 'Time' dial, which can be altered between
8 seconds to 9 minutes duration. See (1) below.
Adjust the light level that the lamp switches on by
adjusting the 'LUX' screw (2).
• Do not exceed the wattage stated or use a different
shape bulb from the indicated on the fitting.
• Unscrew the bulb anti clockwise to remove.
• Carefully locate the bulb in the lampholder and turn
clockwise to secure.
Glass parts – Wipe clean with a damp cloth. Do not use
abrasive materials as these will damage the finish.
Replace Cracked
Shade
EU Manufacturer:
Kingfisher International Products B.V.
Rapenburgerstraat 175E,
1011 VM Amsterdam, The Netherlands.
Instruction leaflet
Half Lantern PIR
Outdoor Wall Light
172PG, 430PG
19/07/2021

Advertisement

loading

Summary of Contents for lap 172PG

  • Page 1 Adjust the light level that the lamp switches on by detection distance is 8m. adjusting the 'LUX' screw (2). Outdoor Wall Light 172PG, 430PG Max. 8M Fitting/replacing bulbs • Fitting/Replacing the bulbs - MAX 15W LED E27 GLS. • Do not exceed the wattage stated or use a different shape bulb from the indicated on the fitting.
  • Page 2 Installation Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Existing fittings must be completely removed before • Refit the plastic cover over the terminal block and installation of a new product.

This manual is also suitable for:

430pg