Pioneer PDP-433MXE Service Manual page 177

Installation using the optional PIONEER stand or
installation bracket
÷ Please be sure to request installation or mounting of this unit or
the installation bracket by an installation specialist or the dealer
where purchased.
÷ When installing, be sure to use the bolts provided with the stand
or installation bracket.
÷ For details concerning installation, please refer to the instruction
manual provided with the stand or installation bracket.
Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
÷ When possible, please install using parts and accessories
manufactured by PIONEER. PIONEER will not he held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
÷ For custom installation, please consult the dealer where the unit
was purchased, or a qualified installer.
a hole
b hole
b hole
CAUTION
To avoid malfunction, overheating of this unit, and possible fire
hazard, make sure that the vents on the main unit are not blocked
when installing. Also, as hot air is expelled from the air vents, be
careful of deterioration and dirt build up on rear surface wall, etc..
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm) bolt. (Only this size
bolt can be used.)
Air vents (fan)
Center line
Rear view diagram
PDP-433CMX, PDP-433MXE
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc.. The installation holes that can
be used are shown in the diagram below.
÷ Be sure to attach in 4 or more locations above and below,
left and right of the center line.
÷ Use bolts that are long enough to be inserted 1/2 inch (12
mm) to 11/16 inch (18 mm) into the main unit from the
attaching surface for both a holes and b holes. Refer to
the side view diagram below.
÷ As this unit is constructed with glass, be sure to install it
on a flat, unwarped surface.
Center line
a hole
b hole
b hole
1/2 inch (12 mm) to
11/16 inch (18 mm)
CAUTION
Because this unit weighs about 88 lbs 3 oz (about 40 kg) and the
lack of depth makes it fairly unstable, please use 2 people or more
when packing, carrying or installing.
CAUTION
This unit incorporates a thin design. To ensure safety if vibrated or
shaken, please be sure to take measures to prevent the unit from
tipping over.
Attaching surface
Installation
bracket, etc..
a hole
Main unit
Bolt
1/2 inches (12 mm) to
11/16 inches (18 mm)
b hole
Bolt
Side view diagram
177