Advertisement
4. PROCEDURE FOR CONNECTING TO THE USER SYSTEM
Before using the header board, mount the supplied NQPACK on the user system.
The header board is connected to the adapter board using the 2 flat cables (standard or long) included
with the adapter (which is sold separately). See the operation manual of the adapter for details on
how to connect the flat cables.
■ Connecting
1. To connect the header board to the user system, align pin 1 indicated by the index mark (▲) on
2. Insert each of the screws for securing the header board through a washer and into each of the four
4
the NQPACK mounted on the user system with the index mark (▲) on the header board and then
insert the header board (see Figure 3).
The YQPACK pins are thin and easy to bend. Check that the YQPACK pins are not bent before
inserting the YQPACK into the NQPACK.
holes in the header board. To tighten the screws, use the special screwdriver supplied with the
NQPACK to evenly tighten the diagonally opposite screws in turn (see Figure 4).
Be careful to avoid overtightening the screws as this may cause a bad connection.
NQPACK
index (▲)
Header board
index (▲)
Figure 3 Index position
B
A
B60
A60
B60
A60
B1
A1
B1
A1
Advertisement
