Table of Contents
Advertisement
Getting help
The optional PCGA-UFD5 (USB) floppy disk drive is not recognised as drive A
To set the UFD5 to A, proceed as follows :
1
Turn the system power on.
2
Connect the UFD5.
3
Select Control Panel from the Start menu.
4
Double-click System.
5
Select the Hardware tab, then click Device Manager.
6
Select Universal Serial Bus controllers, then Y-E Data USB Floppy.
7
From the Action menu, click Uninstall.
8
Keep clicking OK until the Confirmation of deletion of device message appears.
9
Select Scan for hardware changes from the Action menu.
The UFD5 is recognised as drive A.
The floppy disk drive in the docking station connected to the notebook is not recognised as drive A
To set the docking station floppy disk drive to A, proceed as follows :
1
Turn the system power off and disconnect all peripherals.
2
Connect the docking station, then turn the system power on.
3
Select Control Panel from the Start-Settings menu.
4
Double-click System.
5
Select the Hardware tab, then click Device Manager.
6
Select Floppy disk controllers, then Standard floppy disk controller.
7
From the Action menu, click Uninstall.
8
Keep clicking OK until the Confirmation of deletion of device message appears.
9
Perform the Scan for hardware changes from the Action menu.
The docking station floppy disk drive is recognised as drive A.
n N
93
Advertisement
Table of Contents
