Hemp Grow Frame, Lights and Tray
Frame Assembly
Parts List
(11) 28" TUBES
(4) 27" TUBES
(4) 18" TUBES
(4) 14" TUBES
(8) 3-WAY CONNECTORS
(4) 4-WAY CONNECTORS
(2) T CONNECTORS
(2) WIRE SHELVES
1. Assemble the frame as shown in Fig. 1. Make sure the TUBES are fully pressed
into the CONNECTORS.
2. Place the WIRE SHELVES on the top and middle tiers of the frame.
Light Assembly
Parts List
(2) FLAT SUPPORTS
(2) LIGHT BRACKETS with CLIPS
(3) LIGHTS
(1) BINDING BOLT (2 pieces)
(4) BOLTS
(2) LINKING CABLES
(1) POWER CORD
(4) HANGER ASSEMBLIES (Fig. 5 & 6, see reverse side)
3. Line up the holes in the centers of the FLAT SUPPORTS and slide one half of the BINDING BOLT through them. Place the other half
of the BINDING BOLT through the other side and use your screwdriver to attach them (Fig 2.) NOTE: The FLAT SUPPORTS will feel
loose even after tightening.
4. Examine the channels on top of the LIGHT BRACKETS to find the attached nuts (Fig 3.). Use the ALLEN WRENCH to spread them
out and position the holes in the ends of the FLAT SUPPORTS over them. Place a BOLT through each hole and use the ALLEN
WRENCH to tighten them into the nuts.
5. Adjust the ends of the FLAT SUPPORTS so they are centered on the LIGHT BRACKETS, using the numbers on the BRACKETS as a
reference.
Figure 2
BINDING BOLT
BINDING
BOLT
screwdriver
FLAT SUPPORTS
(pressed together)
#8600288, 8600289, 8600301
Tools
ALLEN WRENCH (included)
Phillips or flathead screwdriver (not included)
Figure 3
LIGHT BRACKETS
8% of our profits
Learn more at gardeners.com/
FIGURE 1
3-WAY
3-WAY
18"
4-WAY
27"
3-WAY
FLAT SUPPORTS
go back to our communities.
FoRCE-FoR-GoOD
1-800-876-5520 • gardeners.com
info@gardeners.com
T
28"
4-WAY
28"
3-WAY
28"
LIGHT BRACKET
(top channel)
BINDING
BOLT
nut
BOLT
14"
14"
18"
28"
27"
28"
over please
1331V Rev 11/19