Troubleshooting - Panasonic NA-F150A3 Operating & Installation Instructions Manual

Troubleshooting

Symptoms
Time indication increases
or does not decrease
Operation time is longer
than the time indication.
Operation does not stop
even after the preset time.
No operation
Cannot change process
settings (after start-up).
No water supply
Water is supplied in the
middle of wash process.
The water level is too
high for the amount of
laundry.
The water level is too low
for the amount of laundry.
Operation started with
rinse, but water is not
supplied.
Operation suddenly
changes to rinse process
in the middle of spin.
Only spin is desired, but
operation starts with
rinse.
Irregular rotation during
spin
Power failure/
The breaker has tripped.
Water outage
Cannot select the
Fragrance program.
There is noise when
water drains out
Points to be checked
Time indication is approximate. Remaining time is corrected during
operation and displayed.
The operation time may be longer if laundry is concentrated on one
side or the water supply or drainage is not good.
(P. 16 "U 11" "U 14")
Power failure?
Is the lid closed completely?
Has the power fuse blown or the breaker tripped?
Is the power plug inserted completely?
Is the water faucet turned on?
Did you press "Start"?
Is the timer preset?
Process settings can be changed during wash process by pressing
"Pause". To change the program or settings after the end of wash
SURFHVV WXUQ WKH SRZHU R DQG RQ DJDLQ
Is the water faucet turned on?
Water outage?
,V WKH ZDWHU VXSSO\ ¿OWHU FORJJHG ZLWK GLUW" 3 
If the water level drops, water is added automatically.
With a large amount of laundry, water is added several times
automatically.
If laundry is wet or there is water in the tub before operation, the
water level may be higher.
:LWK OLJKW FORWKHV RI V\QWKHWLF ¿EUH HWF  WKH ZDWHU OHYHO PD\ EH
lower.
If there is no water in the tub, water is supplied after spin.
If there is water in the tub, water is supplied after water discharge.
If clothes are concentrated on one side of the tub, the washing
machine automatically corrects unevenness by starting rinse
process.
(Place clothes as evenly as possible.)
The tub rotation speed is adjusted to reduce foaming during spin.
Operation will resume from the point where it was stopped when the
power is recovered (Auto Restart).
When water supply is recovered, remove the water supply hose,
release turbid water from the faucet, and then start the washing
machine.
If Child Lock (P. 10) is set, the Fragrance program cannot be
selected.
This is normal. It is the noise of the drain pump working.
15