Advertisement
5
3.7 HOW TO REMOVE THE CRG MECHANISM ASSY
1. Remove four Fixing Screws of Upper Chassis and remove the Upper Chassis. (Fig.1 and 2)
(The same applies to the mechanism of the different type of the Upper Case)
2. Remove it from three Dampers while moving the Carriage Mechanism part up (Fig.2).
(Note) When the CRG Mechanism ASSY is reinstalled, apply ethanol to the Dampers.
Check that the tip of Centering Front Spring is inside the bend (Fig.3).
Check that the Damper Shaft is located within the Centering Spring (Fig. 4).
When assembling the CRG Mechanism, create an empty clamp state according to "3.3 HOW TO CREATE EMPTY
CLAMP STATUS (MECHANISM MODULE)(MOTOR-DRIVEN)" and press down the upper part of the Damper of the
CRG Mechanism so that the Damper and the CRG Mechanism are firmly in engagement with each other (Fig. 5).
Fixing Screw of Upper Chassis
Fig.1
Fig.3
The tip of spring should
be within the red circle.
5
6
Fig.2
Fig.4
OK:
The shaft is inside
the spring.
NG:
The shaft is outside
the spring.
CX-3283
6
7
Damper
Fig.5
OK: The upper part of Damper is flat.
NG: The Damper dents.
7
8
A
B
C
D
E
F
27
8
http://www.Datasheet4U.com
Advertisement
