Advertisement
5
3.3 HOW TO CREATE EMPTY CLAMP STATUS (MECHANISM MODULE)(MO-
TOR-DRIVEN)
1. Remove soldering of the CRG Motor Lead Wire (Fig.1).
2. Tuck the Disc Detection Arm while applying 4V to the CRG Motor (Fig. 2).
(green wire – 4V, white wire – GND)
The mechanism is clamped, and the PU moves to the outer circumference.
(Note) Do not apply the current when soldering of the CRG Motor Lead Wire is not removed.
IC and the PU may be damaged.
3. Stop the motor when the PU reaches the intermediate circumference.
(Note) If the PU moves to the outermost circumference, tooth jumping occurs.
There is no problem, but prevent tooth jumping as much as possible.
Fig.1
Fig.2
5
6
Left rear part of mechanism
CX-3283
6
7
7
8
A
B
C
D
E
F
23
8
http://www.Datasheet4U.com
Advertisement
