Sony Vaio PCG-C1XD User Manual page 60

Getting Help
Troubleshooting
Confirm that the power cord and all cables are connected firmly, as described in
"Connecting a Power Source" on page 18.
If you have plugged the computer into an UPS, make sure the UPS is turned on
and working.
If you are using an external display, check that it is plugged into a power source
and turned on. Check that you have switched to the external display and that the
brightness and contrast controls are adjusted correctly. Please refer to the manual
supplied with your display for details.
Moisture condensation may have occurred. Do not use the computer for at least
one hour and then turn it on.
The internal backup battery of your computer may be low on power. To change
the backup battery located on the bottom please contact VAIO-Link.
If any of the above procedures does not work, press the reset switch on the bottom of
the computer with a wire and then restart the computer.
When I turn on my computer, the message "Operating system not found" appears and
Windows does not start
Check the floppy disk drive to see if a non-bootable diskette is in the drive.
If a non-bootable diskette is in the drive, eject it and press any key on your
keyboard. Windows then starts normally.
If Windows still does not start, follow the procedure below to initialize the BIOS.
If the floppy disk drive is empty, follow the steps below to initialize the BIOS:
1
Remove any peripheral devices connected to the computer.
2
Turn the computer off and then turn it on again.
3
Turn on the computer and press the F2 key when the Sony logo appears. The
BIOS setup menu screen appears.
n N 60