Electrical Wiring - LG 100K Installation Manual

Electrical Wiring

!
CAUTION
• The power cable connected to the out-
door unit should be complied with the
tion, type H07RN-F approved by HAR or
SAA) (This equipment shall be provided
with a cable set complying with the na-
tional regulation.)
MODEL
ANUC1008A
ANUC1508A
• The connecting cable connected to the
indoor and outdoor unit should be com-
(Rubber insulation, type H07RN-F ap-
proved by HAR or SAA) (This equip-
ment shall be provided with a cable set
complying with the national regulation.)
MODEL - ANUC1008A / ANNC1008A
MODEL - ANUC1508A / ANNC1508A
• If the supply cable is damaged, it must
be replaced by a special cable or as-
sembly availible from the manufacturer
of its service agent.
NORMAL
CROSS-SECTIONAL
AREA 0.75 mm
2
Area(mm 2 )
6.0
10.0
NORMAL
CROSS-SECTIONAL
AREA 0.82 mm
2
NORMAL
CROSS-SECTIONAL
AREA 3.3 mm
2
INSTALLATION OF UNIT
Precautions when laying power wiring
Use round pressure terminals for connections
to the power terminal block.
Round pressure terminal
When none are available, follow the instruc-
tions below.
nesses to the power terminal block. (Slack in
the power wiring may cause abnormal heat.)
- When connecting wiring which is the same
- For wiring, use the designated power wire
outside pressure being exerted on the termi-
nal block.
- Use an appropriate screwdriver for tighten-
ing the terinal screws. A screwdriver with a
small head will strip the head and make
proper tighterning impossible.
- Over-tightening the terminal screws may
break them.
21
Power wire