Connecting Ied With A Test Switch; Connecting Power Supply - ABB Relion 650 Series Installation Manual

Section 5
Connecting
5.4.2
5.5
30
Table 3: Analog input modules
Terminal TRM
6I + 4U
X101-1, 2 1/5A
X101-3, 4 1/5A
X101-5, 6 1/5A
X101-7, 8 1/5A
X101-9, 10 1/5A
X102-1, 2 1/5A
X102-3, 4 100/220V
X102-5, 6 100/220V
X102-7, 8 100/220V
X102-9, 10 100/220V
See the connection diagrams for information on the analog input
module variant included in a particular configured IED.

Connecting IED with a test switch

When the IED is used with a test switch, connect the current and voltage
transformers directly to the switch.

Connecting power supply

When using power supply 110-250 VDC or 100-240 VAC, connect the IED's
auxiliary voltage to terminals X410-1 and X410–3. When using a DC supply,
connect the positive lead to terminal X410–3.
When using power supply 48-125 VDC, the IED's auxiliary voltage is connected to
terminalsX410-1 and X410–2 with the positive lead connected to terminal X410–2.
The permitted auxiliary voltage range is found from the IED sticker.
Connect power supply to connector X410. Do not accidentally
connect the power supply to connector X309.
TRM TRM
8I + 2U 4I + 1I + 5U
1/5A 1/5A
1/5A 1/5A
1/5A 1/5A
1/5A 1/5A
1/5A 0.1/0.5A
1/5A 100/220V
1/5A 100/220V
1/5A 100/220V
100/220V 100/220V
100/220V 100/220V
1MRK 514 013-UEN -
AIM AIM
6I + 4U 4I + 1I + 5U
1/5A 1/5A
1/5A 1/5A
1/5A 1/5A
1/5A 1/5A
1/5A 0.1/0.5A
1/5A 100/220V
100/220V 100/220V
100/220V 100/220V
100/220V 100/220V
100/220V 100/220V
650 series
Installation Manual