Mms Function; Supported Format; Easy Operation; Power Supply - Braun BLACK400phone Instruction Manual

2.4 MMS Function

This camera can send pictures instantly to your mobile device via the GSM network.
You will be alerted only when something has happened; for sending an MMS via the
GSM network you need to make the settings in the software first. Review the related
information in Chapter 4.1.4 Settings Menu "MMS".
SIM card icon: There are two SIM card icons.
inserted and it works properly.
very good. Without inserting the SIM card or low signal strength,
There are 5 submenu settings for the MMS function, including: APN, MMSC, WAP
Gateway, MMS Phone, MMS Mail (refer to Chapter 4.1). MMS Set means that the
correct MMS settings according to your network are applied. Send to means input
the phone number or email address, to which you want to send. All 5 submenus
must have correct settings.

2.5 Supported Format

Item
Photo
Video
File Format
Here are some important notices. You don't need to concern about the file
system format of the camera unless you have problems with reading the SD-card by
your other equipment. If this happened, please format the SD-card in the camera or
in a computer at first and then reinsert the card into your camera to make a try.

3. Easy Operation

3.1 Power Supply

Open the battery cover. Confirm that the power switch is in OFF position, insert the
fully charged lithium battery into the compartment. Replace the battery cover.
When in Test Mode, camera will be automatically shut down to save power if
without any operation within 3 minutes; it could be waked up by any movement
detection.
When in low-battery state, camera will be also automatically shut down. Please
change the batteries in time.

3.2 Insert the SD-card and the SIM-card

Insert SD-card into the card slot with marked side upwards.
Please note that the SD-card can only be plugged in one direction. Make sure that
means that the SIM card is
means that the network signal in your area is
Format
JPG
AVI
FAT32
will disappear.
7