Table of Contents
Advertisement
Sequential Broadcasting
Sending a document to more than one location
Sequential Broadcasting sends one document to more than one location.
You can send to a total of 31 locations as follows:
One-touch Speed Dialling
Coded Speed Dialling
Regular dialling (Numeric buttons dialling)
You can enter the One-touch Speed Dialling and Coded Speed Dialling locations in any order. You
simply press the One-touch Speed Dialling button, or press [Coded Dial] followed by the two-digit code
(with the numeric buttons).
You can also include one location using Regular dialling. Remember that when using regular dialling,
you must press [Start/Copy] after entering the number.
You can send up to 21 A4-size pages (based on the Canon FAX Standard Chart No.1-standard
resolution).
1
Feed the document face-down into the
Automatic Document Feeder (ADF).
See Loading the document, p. 49.
You can set the resolution and density. See p. 51.
2
Dial the other party's fax number.
¶ You can send to up to 31 locations.
¶ Simply enter the numbers one after the other:
press the desired One-touch Speed Dialling
button or press [Coded Dial] followed by the
two-digit code (with the numeric buttons).
¶ You can enter only one number directly with the
numeric buttons using regular dialling.
Remember to press [Start/Copy] after entering
the number.
¶ You can also press [Redial/Pause] to redial the
last number dialled with the numeric buttons.
¶ You must press each button within 10 seconds of
the preceding one. The fax begins the operation
approximately 10 seconds after you press the last
button.
3
Press [Start/Copy].
¶ The fax reads the document into memory and
begins sending. Between transmissions, MULTI
TRANS. ON displays on the LCD.
¶ To cancel a transmission, press [Stop] during
dialling or transmission. All transmissions in the
sequence are cancelled.
66
=
10 locations
=
20 locations
=
1 location
Start/Copy
STANDARD
TEL=
34567890
TX/RX NO.
XXXX
1 sec.
MEMORY INPUT P01
Advertisement
Table of Contents
