Weider 2250 User Manual page 12

14. Wrap the Long Cable (23) over a "V"-pulley (6).
Attach the "V"-pulley and a Long Cable Trap (50)
to the Front Upright (42) with an M10 x 58mm
Bolt (7) and an M10 Nylon Locknut (21). Make
sure that the Long Cable Trap is positioned to
hold the Cable in the groove of the "V"-pulley.
15. Route the Long Cable (23) around a "V"-pulley
(6). Attach the "V"-pulley and a Long Cable Trap
(50) to the Left Arm (47) with an M10 x 58mm
Bolt (7) and an M10 Nylon Locknut (21). Make
sure that the Long Cable Trap is positioned to
hold the Cable in the groove of the "V"-pulley.
Repeat this step with the Right Arm (48).
16. Route the Long Cable (23) over the 90mm Pulley
(15) attached to the Pulley Bracket (20). Make
sure that the Cable Trap (66) is oriented to
hold the Cable in the groove of the Pulley.
Tighten the M10 x 48mm Bolt (12) and the M10
Nylon Locknut (21).
Properly tighten the M8 x 117mm Bolt (68) and an
M8 Nylon Locknut (3) attaching the Pulley
Bracket (20) to the bracket on the Top Frame
(55). Do not overtighten the Nylon Locknut;
the Pulley Bracket must be able to pivot easily.
17. Wrap the Long Cable (23) under a 90mm Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the indicated hole in the Long "U"-bracket (57)
with an M10 x 48mm Bolt (12) and an M10 Nylon
Locknut (21). Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
All manuals and user guides at all-guides.com
12
14
42
15
48
47
16
20
21
3
23
17
15
12
7
6
50
23
21
7
50
6
23
47
21
68
15
66
12
55
Bracket
23
66
21
57