Pair Your Remote Control To Display; Ir Sensor; Batteries - Philips 7406 Series User Manual

1 - EXIT
To leave from current menu or App.
2 - Volume
Press + or - to adjust the volume level.
3 - Number keys
To select a program directly.
4 - INFO
INFO - Long press to open the programme
information screen.
5 - Program
This feature is not supported.
6 - Mute
Press to mute the sound or to restore it.
7 - SUBTITLE
To open Subtitle page.
3.2
Pair Your Remote Control to
Display
This remote control uses both Bluetooth and IR
(infrared) to send its commands to the display.
• You can use this remote control via IR (infrared) for
most operations.
• To use advanced operation like voice search and
remote control keyboard, you need to pair (link)
the display with the remote control.
When you start the initial display installation,
the display invites you to long
press the PAIR key (approximate for 3 seconds),
after selecting APHRC, pairing will be completed in
10 seconds.
Note:
1 - Once the remote control has entered pairing
mode successfully, the blue LED indicator ring around
the microphone on the front side of the remote
control starts blinking.
2 - The remote control must be kept close to
the display (within 1m distance) during pairing in
order to ensure success.
3 - If the display does not launch the voice control
field when press Google Assistant™, pairing was
unsuccessful.
4 - It is advisable to wait until the set has fully started
up and launched all background processes before
pairing mode is entered as the toast message
containing further instructions may appear too late,
thereby negatively impacting the pairing procedure.
Pairing or pairing again
If the pairing with the remote control was lost, you
can pair the display with the remote control again.
You can simply long press
the PAIR key (approximate for 3 seconds) for
pairing.
Alternatively, go Settings > Remote &
Accessories > Add Accessory, then follow the on-
screen instructions.
A message appears when the pairing is successful.
3.3

IR Sensor

The display can receive commands from a remote
control that uses IR (infrared) to send commands. If
you use such a remote control, always make sure you
point the remote control at the infrared sensor on the
front of the display.
Warning
Do not put any objects in front of IR sensor of the
display, it may block the IR signal.
3.4

Batteries

If the display does not react on a key press on the
remote control, the batteries might be empty.
To replace the batteries, open the battery
compartment on the back-bottom of the remote
control.
1 - Slide the battery door in the direction shown by
the arrow.
2 - Replace the old batteries with 2 type AAA-1.5V
batteries. Make sure the + and the - ends of the
batteries line up correctly.
3 - Reposition the battery door and slide it back until
it clicks.
6