Table of Contents
Advertisement
8.0 Controls Functions
8.1 Control Panel Buttons
Figure 8-1
8.2 RF Remote Control
Figure 8-2
POWER ON/OFF SWITCH – A
The Power ON/OFF switch (Fig. 8-1, A) is a rocker
switch on the control panel used to supply power to
the AFS electronic controls and thus the full AFS.
In the OFF position, AC power is disconnected from
the electronics. The AFS unit will Not turn On.
In the ON position, AC power is connected to the
electronics. The electronics are powered On in a
STANDBY state awaiting user input via the ON/OFF
button on either the control panel or the remote.
ON/OFF BUTTON (control panel or
remote) – B
The On/Off Button (Fig. 8-1 and 8-2, B) on the
controls and the remote perform the exact same
function under the exact same conditions.
B
A
B
11
When the Power switch (Fig. 8-1, A) is first turned
ON, power is supplied to the electronics and the
AFS unit is in the STANDBY state. All DISPLAYs
are off.
Each press of the ON/OFF button (Fig. 8-1 and 8-2,
B) cycles the AFS unit between STANDBY and ON.
Pressing the ON/OFF button once:
•
AFS Unit goes to ON state.
•
The TIMER DISPLAY is blank.
•
The fan starts to run at speed 1.
•
The SPEED DISPLAY shows 1 bar for speed 1.
•
The FILTER DISPLAY will illuminate the filter
status.
Pressing the ON/OFF button again does the
following:
•
AFS unit goes to STANDBY state.
•
All DISPLAYS are off, and the fan stops.
TIMER (control panel or remote)
The TIMER buttons (Fig. 8-1 and 8-2) on the
controls and the remote perform the exact same
function under the exact same conditions.
The TIMER may be set in 1-hour increments from 1
to 16 hours. When the timer expires, the fan will stop
and the AFS will enter STANDBY state.
When the timer is not being used, the TIMER display
will be blank and the AFS will run continuously until
the user changes the settings or stops the AFS.
To activate the TIMER, pressing the TIMER + button.
•
The TIMER DISPLAY changes from blank to
display flashing "1". This is 1 hour.
•
Pressing the TIMER + button again will increase
the number by 1 each time the TIMER + button
is pressed. Up to a maximum of 16 hours.
•
Pressing the TIMER – button will decrease the
number by 1 each time the TIMER - button is
pressed. Down to a blank display turning the
TIMER Off and running the AFS continuously.
•
If the display is already set and showing an hour
time value, then pressing the TIMER + or –
button will add or subtract time from the already
set value.
•
When the TIMER + or – button have been
pressed, the number on the TIMER display will
flash for 1 second and then show steady ON.
Steady ON indicates the TIMER is set and the
countdown has begun.
•
Pressing and holding either the TIMER + or –
button (2 seconds) will advance the count
quickly (changing every 0.2 seconds) until the
button is released.
Advertisement
Table of Contents
