CUSTOMER SERVICE / TECHNICAL SUPPORT If you have questions about ordering Pentair Commercial Aquatics™ replacement parts, and pool products, please contact: Customer Service and Technical Support, USA Sanford, North Carolina (8 A.M. to 5 P.M. ET) (8 A.M. to 5 P.M. — Eastern/Pacific Times)
230 VAC charge even when there is no This guide provides installation and operation instructions for this product. power to the unit. Consult Pentair with any questions regarding this equipment. • The pump is not submersible. Attention Installer: This guide contains important information about the •...
Page 4
For Installation of Electrical Controls at Equipment Pad (ON/OFF Switches, Timers and Automation Load Center) Warnings and safety instructions for Pentair Water Pool and Spa, Inc. Install all electrical controls at equipment pad, such as pumps and other related products are available at: on/off switches, timers, and control systems, etc.
4. Press seal spring member (16) on motor shaft with carbon face towards ceramic seal member. Avoid cutting rubber parts on shaft. 5. Line up keyways and push impeller (15) on motor shaft up C SERIES PUMP DIMENSIONS 6”-125lb. ASA to shoulder. Insert square key (21) in place.
Maximum Water Temperature = 40°C Non-Submersible Pump IP Rating: IP24 Wiring used for connection to pump must have a minimum wiring insulation rating of 90°C. Motor HP Maximum Total Head 25.00m 28.35m 31.10m 40.85m 42.07m C SERIES Bronze Commercial Pump Installation Guide ®...
Page 8
Unless expressly noted, names and brands of third parties that may be used in this document are not used to indicate an affiliation or endorsement between the owners of these names and brands and Pentair Water Pool and Spa, Inc. Those names and brands may be the trademarks or registered trademarks of those third parties.