Node Integrated Sight Block - Price Parc Node Recessed Channel Installation Manual

Recessed Channel Installation Guide

Node Integrated Sight Block

The sight block is included in any location where the Node Plenum is not installed. The sight block comes pre-installed
in the trough. The sight block can be trimmed on site to allow the passage of airflow below the plenum. The sight block
can be cut before or after the channel is installed in the ceiling, but should only be done once the plenum positioning is
known.
The sight block is made up of an extruded plastic and can be easily cut with a sharp utility knife, marking out the area
where the plenum box will be situated and scoring the plastic extrusion whilst still installed in the channel. Once three
sides have been cut, the plastic can be twisted and snapped off to reveal an opening within the sight block.
Note: Always use appropriate Personal Protective Equipment and follow Risk and Method statements when cutting materials.
SIGHT BLOCK ON BOTH
SIDES OF THE CHANNEL
(INSTALLED BY OTHERS -
TRIMMED AS REQUIRED)
NO DIFFUSER CONDITION
v001 | Recessed Channel Installation Guide
Figure 6
SIGHT BLOCK ON BOTH SIDES OF THE CHANNEL
(INSTALLED BY OTHERS - TRIMMED ON SITE AS REQUIRED)
SIGHT BLOCK PRE-INSTALLED
SIGHT BLOCK PRE-INSTALLED
TWIST AND SNAP ALONG BLUE LINE
TWIST AND SNAP ALONG BLUE LINE
CUT ALONG BLUE LINE
CUT ALONG RED LINE
OPEN SLOT FOR SUPPLY OR RETURN
Figure 8
Figure 9
Figure 7
6