Related Manuals for Wine racks America KD-144 Series
Summary of Contents for Wine racks America KD-144 Series
- Page 1 ASSEMBLY INSTRUCTIONS: KD-144,72,50 SERIES COMPONENTS: (1) Front Panel (1) Rear Panel (2) Side Support (8) Dome Nut (8) Elevator Bolt (2) Support Hook NOTE: WHEN ASSEMBLING THE RACK, DO NOT FIRMLY TIGHTEN BOLTS UNTIL THE RACK HAS BEEN LEVELED.
- Page 2 Figure 1 Figure 2 1. Locate the front panel and two side supports. 2. Place an elevator bolt through the side face of the front panel just below the second horizontal wire from the top. (Fig. 1) 3. Make sure the head of the elevator bolt is below the wire as shown. (Fig. 2) Figure 3 Figure 4 4.
- Page 3 Figure 5 Figure 6 6. At this point the rack should look like the photo shown above. (Fig. 5) 7. Locate the rear panel and place an elevator bolt through the side face of the front panel just below the third horizontal wire from the top. (Fig. 6) 8.
- Page 4 11. IMPORTANT: The two support hooks must be installed prior to loading the rack. Connect the support hooks from the front panel to the rear panel at the third row from the top on the front and at the forth row near the middle of the rack as viewed from the front. (Fig. 8) Note: WHEN PROPERLY ASSEMBLED BOTH THE FRONT AND REAR PANELS WILL SIT APPROXIMATELY 5 INCHES OFF THE FLOOR.
Need help?
Do you have a question about the KD-144 Series and is the answer not in the manual?
Questions and answers