Samsung DMR78 Series Service Manual page 34

3. Disassembly and Reassembly
Part
Inlet Valve &
Flow Meter
3-20
All manuals and user guides at all-guides.com
Photo
1. Place the dishwasher on its back and remove two
2. Remove the water supply line (and elbow)
3. Remove the four(4) screws on both sides of the
4. Remove the two (2) screws and ground wire screw
5. Hold and lift up the inlet valve and release flow
6. Pull out the inlet valve until the hose clamp can be
Description
(2) screws on both sides of the cover front lower.
Remove the cover front lower.
Caution
Make sure to close the faucet before removing the
water supply line.
bracket front lower.
Remove the bracket front lower after the guide wire's
4 hooks release .
* If the legs are in the way removing the screws,
unfasten it a little in the clockwise direction and
remove the screws.
from the inlet valve.
meter's clasp on the bottom of the base.
* When release flow meter's clasp, push-up using
tool.
removed, and remove the clamp and hose.
Caution
Take care when holding and removing the clamp
with a tool, as it may bounce and harm you.