Advertisement
Quick Links
Assembly Instructions
CM7811Q
ASSEMBLY RATING
Tools Required for Assembly:
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
Allen Wrench
(Included)
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Phillips Screwdriver
(Not Included)
DIFFICULT
EASY
2 PERSONS RECOMMENDED
Page 1 of 7
Rev.14-03-20
Advertisement
Related Manuals for Furniture of America CM7811Q
Summary of Contents for Furniture of America CM7811Q
- Page 1 Assembly Instructions CM7811Q ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench (Included) assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
- Page 2 Page 2 of 7...
- Page 3 Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed. Parts List Hardware List #A x 6 pcs #1 x 1 pc Bolt 1/4”x1-3/4” Left Headboard Post #B x 14 pcs #2 x 1 pc Lock Washer...
- Page 4 Due to the size and/or weight of this product, it is highly recommended that the assembly should be done near the area of its intended location. Make sure you have enough space to move around during the assembly. ALWAYS have at least two people to help with transporting and assembling of the product and to avoid any potential injury and/or damage.
- Page 5 Align the left and right headboard posts (#1 & #2) with the headboard (#3). Prepare 6 bolt assemblies by inserting FIRST the lock washer (#B) onto the bolt (#A) and then the flat washer (#C) onto the SAME bolt (#A), in that order. III.
- Page 6 #B x 8 pcs Turn right (clockwise) to tighten #C x 8 pcs Prepare 4 bolt assemblies by inserting #G x 8 pcs FIRST the lock washer (#B) onto the bolt (#G) and then the flat washer (#C) onto the SAME bolt (#G), in that order. Insert the 4 bolt assemblies through the pre-drilled holes of the left and right headboard posts (#1-#2) using the Allen...
- Page 7 Align the threaded end of the slat support leg (#9) with the pre- drilled holes of the slat (#8) and tighten by hand until secured. Repeat the process for attaching the remaining 3 slat support legs (#9) onto the slats (#8). Enlarged Turn right (clockwise) to tighten Align the ends of the 4 assembled slat (#8) with the pre-drilled...
Need help?
Do you have a question about the CM7811Q and is the answer not in the manual?
Questions and answers