Advertisement
Quick Links
Assembly Instructions
CM7811M
CM7811D
DRESSER AND MIRROR ARE SOLD AND PACKED SEPARATELY
ASSEMBLY RATING
Tools Required for Assembly:
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
(Included)
Allen Wrench
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
DIFFICULT
EASY
2 PERSONS RECOMMENDED
Page 1 of 6
Rev.14-03-17
Advertisement
Related Manuals for Furniture of America CM7811D
Summary of Contents for Furniture of America CM7811D
- Page 1 Assembly Instructions CM7811M CM7811D DRESSER AND MIRROR ARE SOLD AND PACKED SEPARATELY ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in (Included) Allen Wrench assembling a specific product (with 1 being easy and 5 being difficult).
- Page 2 Page 2 of 6...
- Page 3 Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed. Hardware List Parts List #A x 8 pcs #1 x 1 pc Bolt 1/4”x1-1/2” Dresser #B x 8 pcs #2 x 2 pcs Lock Washer Front Leg w/Leveler...
- Page 4 Due to the size and weight of this product, it is highly recommended that the assembly should be done near the area of its intended location. Make sure you have enough space to move around during the assembly. ALWAYS have at least two people to help with transporting and assembling the product and to avoid any potential injury and/or damage, especially with the fragile nature of the mirror.
- Page 5 Align the threaded end of the support leg (#6) with Step 2 the pre-drilled hole on the bottom of the dresser (#1) and tighten by hand until secured. Enlarged Turn right (clockwise) to tighten The two mirror support brackets (#5) are already attached behind the dresser.
- Page 6 Adjust the leveler according to the ground level. To Step 4 lower or to raise the support leg (#6), you need to turn the leveler clockwise or counterclockwise, respectively. Tilt the shelf (#7) at an angle and gently have it rested and leveled on top of the shelf supports.
Need help?
Do you have a question about the CM7811D and is the answer not in the manual?
Questions and answers