ViewSonic N4285p-4M Service Manual page 25

Using VGA Function
1. When in VGA source, press the MENU button to
display the OSD main menu.
2. Press ▲ or ▼ to select the "Video" menu.
3. Press ENTER or ► to enter "Video" menu.
4. Press ▲ or ▼ to select your desired controls, and press
◄ or ► to adjust.
4. For advanced VGA functions, select "VGA" (only
enabled in VGA source) and press ENTER to enter
VGA setting.
5. Press ▲ or ▼ to select "H. Position", "V. Position",
"Phase", or "Clock", and adjust the level with ◄ or ►.
＊When in VGA source, the Audio, and Setup menus
are the same as or similar to when in other source.
Instead that some controls are disabled.
＊When there is no signal in the VGA mode, "No signal
" will be displayed on the screen,and the TV will
automatically turn into power-saving mode after a
few seconds' idleness. Press POWER or INPUT on
the remote control, or press POWER on the TV panel
at any time and the TV will return to VGA mode.
To Restore Factory Setting
1. Press the MENU button to display the OSD main menu.
2. Press ▲ or ▼ to select the "Setup" menu.
3. Press ENTER or ► to enter "Setup" menu.
4. Press ▲ or ▼ to select "Memory Recall", then press
ENTER to restore the factory default setting.
Setting RS232 Parameter
1. Press the MENU button to display the OSD main menu.
2. Press ▲ or ▼ to select the "Setup" menu.
3. Press ENTER or ► to enter "Setup" menu.
4. Press ▲ or ▼ to select "TV ID", then press ◄ or ►
to set the TV ID number from 01~99. For detailed
information, refer to the RS232 Protocol on page 42~52.
ViewSonic Corporation
22
Confidential - Do Not Copy
N4285p-4M