ViewSonic N4285p-4M Service Manual page 19

Storing Channels into Memory
1. Press the MENU button to display the OSD main menu.
2. Press ▲ or ▼ to select the "TV" menu.
Press ENTER or ► to enter the menu.
Press ▲ or ▼ to select "Tuner Mode", and use ◄ or ►
to select the antenna connection to "Air" or "Cable".
Air: RF signal programs by "Air".
Cable: RF signal programs by "Cable".
3. Press ▲ or ▼ to select "Auto Scan", then press ENTER
or ► to perform Auto Scan function.
To stop scanning, press MENU at any time.
4. The Auto Scan screen will be shown, and after it is
done, the screen will return to the first found channel.
Viewing the Menus
1. Press the MENU button to display the OSD main menu.
There are four top menus on the screen: Video, Audio,
TV, Setup. (TV menu can only be enabled in TV
source.)
2. Press ▲ or ▼ to select your desired top menu.
3. Press ENTER or ► to enter the menu you select.
4. Use ▲▼ to select the control you want to adjust.
5. When selecting the control with ►, press ENTER or
► to enter next level menu or to enable the function.
6. Press ◄ or ► to adjust or select the settings.
7. Press MENU to return to the previous page or exit from
the OSD menu.
Selecting the Input Source
To select the TV or other external input sources connected
to the TV.
1. Press the INPUT button on the remote control.
2. Press ▲ or ▼ to select the required input source between
TV, AV, S-Video, YPbPr 1, YPbPr 2, HDMI 1,
HDMI 2, VGA or USB (When in USB input source, the
system only supports JPEG image files.).
3. To confirm the selection, press ENTER.
ViewSonic Corporation
16
Confidential - Do Not Copy
N4285p-4M