ViewSonic N4285p-4M Service Manual page 10

Chassis Color Drift Due to UV-Light
Molded Plastic
Screen Printed Parts, Bird Logo Recess
Rear Label
Wall Mount
Sample
In addition, all exterior surfaces shall have uniform texture/color. The maximum acceptable gap between the
buckets to bezel plastic pieces shall be within 1.5 mm. The maximum acceptable gap between LCD panel and
bezel shall be within 2.5 mm.
8. Environmental
Operating Temperature
Humidity
Altitude
Storage Temperature
Humidity
Altitude
ViewSonic Corporation
The color drift due to UL-Light shall be less than 10
"Delta E" in the 1976 CIE L*a*b color space. Testing
shall be performed according to the requirements of
ASTM Test Method D4459-93.
Workmanship shall be inspected according to
ViewSonic Molded Plastic Parts Specification,
VSCMPPSPEC001V1.2.
Artwork shall be provided and confirmed by ViewSonic.
A label identifying the product name, model/serial
number and FCC ID/Logo shall be placed into the rear
label recess located on the rear panel of the chassis.
200mm x 400 mm VESA high hole (n=4),pattren
6mm,1.0 pitch x 10 mm long screw mounting kit not
included.
Sample of textured color chips, plastic material
specification, and Material Safety Data Sheets shall be
submitted to ViewSonic prior to Mass Production
Release.
0°C to +40°C
0 ~ 65% non-condensing
0 meter to +2000 meters above sea level
-20°C to +60°C
0 ~ 90% non-condensing
0 meter to 12,000 meters above sea level
7
Confidential - Do Not Copy
N4285p-4M