Using The Self-Timer - Canon PowerShot TX1 User Manual

Using the Self-Timer

1.
Press the Multi Controller towards
press it
• When the shutter button is pressed fully, the self-timer will
activate and the self-timer lamp will blink (when using red-eye
reduction, it will stay lit for the last 2 seconds).
To Cancel: press the Multi Controller towards
10 sec. Self-Timer: shoots 10 sec. after you press the shutter
button.
• 2 sec. before the shutter releases, the self-timer lamp and sound
speed up*
2 sec. Self-Timer: shoots 2 sec. after you press the shutter
button.
• The self-timer sound beeps quickly *
button and the shutter releases 2 sec. later.
Custom Timer: you can change the delay time (0–10*
30 sec.) and number of shots (1–10 *
• When [Delay] is set to 2 or more sec., the self-timer sound begins
to beep quickly 2 sec. before the shutter releases. When [Shots]
is set to more than 1, the self-timer sound only beeps before the
first shot.
*1 This may differ depending on your My Camera settings (Advanced Guide
p. 112).
*2 Default setting.
*3 Default setting is 3 shots.
The self-timer cannot be used in some shooting modes.
See the Advanced Guide: Functions Available in Each Shooting Mode (p. 160).
See Selecting a Shooting Mode (p. 12).
or to display
.
1
( ) and then
, or (
and select
when you press the shutter
1
) (p. 18).
3
).
.
2 , 15, 20,
17