Using Your Machine - Vax U86-PC Series Let's Get Started

Performance floor & dust

Table of Contents

Before you begin cleaning

• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing and

emptying the dirt container

• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat will

automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical socket. Remove

and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour

(if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting back into the vacuum)

• For best cleaning results filters require cleaning at least every 3 months

• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage

• When using the accessories always make sure the brushbar is switched to the off position

Turn the quick

release cord hook to

one side to release.

Plug in the machine

Plug in the machine.

Press the power

on/off button.

Using Accessories

To Release the handle

extension, press the

handle release button

and pull the handle up

to remove

*Not applicable for all models

Tilt the machine back on rear wheels and

set the height adjuster to the desired height

setting

NOTE: For thick carpets turn the brush bar off

Always select the correct height adjuster setting

for your carpet, if the machine is set to low it

may be hard to push and can cause damage to

your carpet

Place your foot on

To release the handle

the floorhead and

extension remove the hose

pull the handle

from the hose holder and press

backwards to recline

the handle release button, pull

the vacuum cleaner

the handle up to remove

For extra reach the extension

tube can be attached to the

handle extension