Advertisement
Safety Instruction
1. Read these safety instruction carefully。
2. Keep this user manual for later reference。
3. Disconnect this equipment from any AC outlet before
Cleaning. Use a damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socket must be
Located near the equipment and easily accessible.
5. Protect the equipment from humidity.
6. Position the equipment on a reliable surface during
Installation. Dropping or letting the equipment fall can
cause damage.
7. Ensure the power supply voltage is correct before
connecting the equipment to a power outlet.
8. Position the power cord away from high-traffic areas.
Do not place anything over the power cord.
9. All cautions and warnings on the equipment should
be noted.
10. If unused for a long time, disconnect the equipment
from the power source to avoid damage from transient
over voltages.
11. Never pour liquid into the equipment openings. This
can cause fire or electrical shock.
12. Never open the equipment. For safety reasons, the
equipment should only be opened by qualified service
Personnel.
13 . If any of the following occurs, have the equipment
checked by service personnel:
The power cord or plug is damaged
Liquid has penetrated into the equipment
The equipment has been exposed to moisture
The equipment is malfunctioning, or does not
operate according to the user manual.
The equipment has been dropped or damaged
The equipment shows obvious signs of
breakage.
14 Do not leave this equipment in an environment with a
temperature out of our suggestions. The equipment
should be kept in a controlled environment.
Operation temperature : -20 ~60°C
Storage temperature : -30~70°C
15. There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the same
or equivalent type recommended by the manufacturer,
and discard used batteries according to the
manufacturer's instructions.
DISCLAIMER ：These instructions are provided according
to the IEC 704-1 standard. Advantech assumes no
responsibility for the accuracy of this manual.
Safety Precaution – Static Electricity
Follow these simple precautions to protect yourself from
harm and the products from damage.
1.
To avoid electrical shock, always disconnect the
power from your PC chassis before you work on it.
Don't touch any components on the CPU card or
other cards while the PC is on.
2.
Disconnect power before making any configuration
changes. The sudden rush of power as you connect a
jumper or install a card may damage sensitive
electronic components.
I/O Introduction
I/O
SIM card/Micro SD card/Micro USB
Dimension
PWS-472 Startup Manual 2
Advertisement
