Turning Square Corners - Singer 14 U44B/244B Operator's Manual

* Fold the fabric with the wrong sides together and
sew.
* Press the pin tucks in the same direction.

* TURNING SQUARE CORNERS

(1) Outside Corner
* Cut out approximately 2 cm (51/64 inch) from
the corner, in line with the overedge seam edge.
* Sew one stitch beyond point (A) and stop.
* Raise needle and presser foot.
* Pull the fabric to the rear of the machine just
enough to release the thread caught on the finger
of the throat plate.
Note: Presser foot has been removed to show detail.
* Turn the fabric and lower the presser foot so that
the knife is positioned in line with the cut edge.
* Pull slack threads up, then start to sew.
(2) Inside Corner
* Cut fabric at seam edge.
32
■
Cutting
line I
(A)
2cm
2cm