* Thread the looper area of the machine following
the yellow color coded thread guides (5)'^(7) •
* Remove the cylinder cover (page 9) to expose the
lower looper for threading.
* Turn the hand wheel toward you until the lower
looper is at the far left.
* Pull 7.5 ~ 10 cm (3 ~ 4 inches) of thread through
thread guide (8).
* Insert the thread through the left end of the lower
looper. (D
* Drop the thread.
Note: Use the tweezers that are in the accessory set
to aid in threading the looper.
* Turn the hand wheel toward you until the lower
looper is at the far right.
*
Pick up the thread and pass it through the hole in
the end of the looper @ .
* The thread should be positioned in the groove of
the lower looper.
* Pull about 5 cm (2 inches) of thread through the
looper and place it over the top of the upper
looper and to the back of the throat plate.
13