Audio Settings - Sony BDP-CX7000ES Operating Instructions Manual

Audio Settings

The default settings are underlined.
Audio Output Priority
Selects the jack type to output audio signals.
2-channel linear PCM signals are output at
48 kHz maximum from output jacks other
than the priority jacks.
HDMI
Outputs audio signals from
the HDMI OUT jack.
Coaxial/ Outputs audio signals from
Optical
the DIGITAL OUT
(OPTICAL/COAXIAL)
jack.
Multi Channel Select this when connecting
Analogue an AV amplifier (receiver)
via the MULTI CHANNEL
OUTPUT jacks.
Stereo
Outputs audio signals from
Analogue
the AUDIO OUT (L/R)
jacks.
Speaker Settings
To obtain the best possible surround sound,
set for the type of speakers you are using, and
their distance from your listening position,
then use the test tone to adjust the volume and
the balance of the speakers.
This setting is available when "Audio Output
Priority" is set to "Multi Channel Analogue."
To set the speakers
1
Select "Speaker Settings" in "Audio
Settings," and press
2
Select "Size," "Distance," and press
3
Select a setup item using V/v, and press
.
4
◆Size
Selects the size of the speakers.
• Front
• Centre
• Surround
• Surround Back
.
.
Select and adjust settings using V/v, and
then pressing .
Large Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
Large
Normally select this
position.
Small
Select this when the speaker
cannot reproduce adequate
low frequencies.
None
Select this if you do not
connect a centre speaker.
Large
Normally select this
position.
Small
Select this when the
speakers cannot reproduce
adequate low frequencies.
None Select this if you do not
connect surround speakers.
Large Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
None
Select this if you do not
connect surround back
speakers.
69
,continued