Register Pass Frequency; Manually Adding A Pass Frequency - AOR AR5000A Operating Manual

Frequencies which have been registered as a pass
frequency will not be received during a subsequent search.
All search banks are independent from each other. For
this reason a frequency selected as PASS in one bank
will not automatically be passed in another bank, it will
only be skipped over in the bank in which it is registered.
Note: Any active frequency within ± 10 kHz of the passed
frequency will be ignored so that all the pass channels do
not have to used up in one particular noisy part of a band,
this must be noted when small steps sizes such as 50 Hz
or 100 Hz are used for SSB and CW monitoring.

13-1 Register PASS Frequency

You can register any frequency as a PASS frequency when
program search has stopped.
While search has stopped on a busy frequency press
, the displayed frequency will be instantly registered
as a PASS frequency and the search will immediately
resume.
If in VFO mode (or manual search or simple search)
frequencies may also be registered as PASS by pressing
the key. In this instance the frequency will be added
to the VFO pass list (as opposed to banks 00 ~ 19).
A beep will sound if all 100 PASS frequencies have already
been registered on the bank in use indicating that no more
frequencies may be passed.

13-2 Manually adding a PASS frequency

using the PASS menu
It is possible to register pass frequencies using the pass
menu. This is particularly useful for eliminating known
troublesome blank carriers even before you start to search!
To access the pass menu, press and hold the
for more than one second.
F-PASS F-PASS" will be displayed with an identifying F-PASS
The legend "F-PASS F-PASS
bank number or legend "VFO
whether the receiver is currently in program search mode
(in which case the current bank number will be displayed)
or VFO (or manual search or simple search) mode.
Rotate the SUB DIAL to select the required bank number
(00 ~ 19 or VFO).
VFO" to the right depending VFO VFO VFO
Press the
selected bank number will be displayed under the legend
"BANK", if in VFO mode the bank number will be replaced
by the letter "V V V V V ".
If no pass channels are currently allocated for the selected
bank, the legend "- - - - - - - - - -" will be displayed.
If pass frequencies have already been registered, pass
channel numbers will have been automatically allocated
starting at 00 through 99. The first pass channel will be
displayed (with the legend "00
the bank number).
Rotate the SUB DIAL to review the pass channels, the first
available empty channel may be displayed ready to accept
data input, the legend "- - - - - - - - - -" identifies the empty
channel.
To register a new pass frequency, key in the desired
frequency finishing in
for 123 MHz.
key
Rotate the SUB DIAL to select the next empty pass channel
and continue to build up the list of frequencies to be
skipped.
To select another bank press the
the first menu and repeat the above process for another
bank.
To accept the input and complete the process, press
in either of the two menus.
key to enter add/edit/delete mode. The
00" being displayed under 00 00 00
or . i.e.
key to return to
AR5000 OPERATING MANUAL PAGE 59