Advertisement
Installation Procedure
IMPORTANT NOTICE
To prevent breakage or distortion, do not use oil-based
caulking or putty to connect the overflow assembly. Oil-based
plumber's putty will have a harmful effect on the overflow
assembly, resulting in a leak. If a sealant is required between
the overflow assembly and the tail pipe, use silicone sealant.
13. Install tail pipe onto the sink ring.
VI-051
14. Tighten the tail pipe assembly onto the sink
VI-052
IMPORTANT NOTICE
Do not overtighten the nut when installing the tail pipe. Hand-
tighten the nut and then tighten NO MORE than one-half turn.
Overtightening will break the overflow assembly and void the
warranty.
15. Turn on water and check for leaks.
Undermount Installation
Note: If undermount installation is required to be ADA
compliant, refer to the wall mount installation and ADA
sections.
Note: Steps 1 through 3 are working from top of the
countertop.
1.
Position template on countertop in desired location.
The Swan Corporation – Swanstone
No Plumber's
Putty in this
location
12
2.
Cut opening and finish the edge of the hole.
WARNING
D D u u s s t t H H a a z z a a r r d d
When sanding Swanstone product,
use a dust collection method which
prevents dust particles from going into the air. Always work
in a well-ventilated area. To keep the area well ventilated,
open windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
Note: Remaining steps are working from underside of the
countertop.
3.
Place bowl into desired position, making sure that
overhang is uniform and aligned with the cutout.
4.
Using 3" wide strips of ¾" thick plywood, trial fit the pieces
around bowl perimeter making sure not to cover faucet
openings. Make sure there is 1/4" space between
plywood strips and bowl flange.
5.
Using construction adhesive, fasten plywood strips to
countertop surface. For maximum adhesion of plywood
strip to countertop, use the manufacturer's recommended
curing time.
6.
Clean bowl and bottom of the countertop surface with
denatured alcohol. Remove all dust. Let the surface dry
completely.
VI-034
VI-036
800-325-7008
Advertisement
