Advertisement
3.
Attach template to counter with masking tape and trace
inside template with a pencil.
4.
Drill starter hole inside of cutout line.
5.
Use a saber saw to cut inside of cutout line.
WARNING
D D u u s s t t H H a a z z a a r r d d
When sanding Swanstone product,
use a dust collection method which
prevents dust particles from going into the air. Always work
in a well-ventilated area. To keep the area well ventilated,
open windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
6.
Trial fit bowl for proper fit. Trim or sand as needed for
proper fit.
800-325-7008
7.
Install faucet per the manufacturer's instructions.
8.
Clean bowl flange and countertop with denatured alcohol.
Remove all dust. Let the surfaces dry completely.
VI-040
9.
Apply a bead of silicone around the underside of sink
flange and position it over the countertop opening.
VI-043
VI-041
sealants and denatured alcohol. Alcohol vapors are both
flammable and hazardous to breathe. Silicone vapors may
irritate eyes and nose. Personal injury can result from
improperly handling or use of products, such as denatured
alcohol.
recommendations for the safe use of these products.
Ventilate any work area before beginning to apply silicone
sealants, cleaning agents, or solvents.
VI-042
10. Tighten the clips in front and rear of sink.
VI-045
11. Use a soft cloth with mineral spirits to remove any excess
silicone.
15
Installation Procedure
WARNING
S S o o l l v v e e n n t t s s H H a a z z a a r r d d
Follow
all
safety instructions for silicone
Always
follow
the
The Swan Corporation – Swanstone
manufacturers'
manufacturer's
Advertisement
