Advertisement
Note: If you do not press Start/Stop within 10 seconds after making your temperature setting selection,
the kettle will revert to stand-by mode.
Note: The target temperature may be changed at any time during any heating function. While heating,
simply press the increase or decrease (< or >) buttons accordingly.
Keep warm function:
1. This kettle can maintain your target temperature for up to 40 minutes.
2. Once your target temperature has been selected, press the Keep warm button. The button will remain
illuminated while the function is activated.
3. To turn off the function, press the keep warm button at any time while it is illuminated. It will also turn
off automatically after 40 minutes.
Note: If you press the Start/Stop button while the keep warm mode is active, the KEEP WARM button
turns off and the kettle starts heating at 100 degrees.
To cancel heating:
1. You may cancel the heating function at any time by pressing the Start/Stop button (Boiling water
mode only).
To use the tea infuser:
1. Slide the steel tea infuser into the easy lift ring until it fits snugly into place.
2. Place your preferred loose tea leaves in the tea infuser basket.
3. Fill the glass jug with the desired volume of water. Minimum 0.6L, Maximum 1.7L.
4. Select temperature and heat water as normal.
5. Once temperature has been reach, open lid and lower tea infuser into the hot water. Let sit to steep
tea.
To use the glass insert:
1. Slide the glass insert into the easy lift ring until it fits snugly into place.
2. Pour your combine sauce ingredients, baby food or chocolate into the glass insert.
3. Fill the glass jug with no more than 1.2 liters of water.
4. Carefully lower the glass insert into the glass kettle with the water.
5. Securely attach the lid. Then, place glass jug assembly on the base. The kettle is now in stand-by
mode.
6. Press the Start/Stop button. Then press either the increase or decrease heat setting buttons (< or >).
7. Continue pressing the increase or decrease buttons until the desired temperature setting is reached.
Then press the Keep warm button.
CAUTION: Keep enough water on the minimum water level (0.6L).
Note: If the Preset temperature is set to 100 °C, the keep warm function will be unavailable.
CLEANING AND CARE
1. Before cleaning, always unplug the appliance. Wipe the outside of the kettle with a damp cloth.
Occasionally rinse out the kettle with clean water. Warning! Never immerse the housing, plug, and
cord in water or any other fluid.
2. To clean the mesh filter, grab the mesh filter and lift it out. Rinse under clean, running water, and insert
it back into the kettle in the correct orientation. To clean the base plate, you may wipe clean with a
damp cloth.
3. Decalcifying is recommended every three months for best performance. Fill the kettle with water and
decalcifier according to decalcifier product instructions. Do not boil the solution as it may foam over.
Afterward, rinse the inside of the kettle with fresh water.
Enjoy your new Electrolux product!
www.electrolux.com
EN
CNS
CNT
KR
ID
TH
VN
7
Advertisement
