Changing The Command Mode Of The Receiver - Sony STR-DE495 Operating Instructions Manual

Adjustments using the SET UP menu
(continued)
x Decode priority (DEC. XXXX)
Sets the appropriate decoding for incoming
digital signals.
• PCM priority mode (DEC. PCM)
Use to enjoy playback from audio CD
(PCM) and DVD. When used with media
other than CD or DVD, you may experience
noise. If this happens, switch to AUTO
mode.
• AUTO mode (DEC. AUTO)
Use to enjoy playback from audio CD
(PCM), DVD, DTS-CD and DTS-LD
sources. However, with audio CDs, you may
not be able to listen the very first moments
of each track.
Normally, use as-is with the initial settings
above.
Changing the command
mode of the receiver
This function is useful when you use 2 Sony
receivers in the same room.
1
Turn off the receiver.
2
Hold down ENTER and press 1/u to
turn on the receiver.
"C.MODE.AVX" appears in the display.
Each time you repeat the procedure above,
the display changes as follows:
C.MODE.AV1 y C.MODE.AV2
Tip
The initial setting is "C.MODE.AV2".
Notes
• The command mode of the supplied remote is
"AV2" and you cannot change this setting.
• If the command mode of the receiver and the
remote is different, you cannot use the remote to
operate the receiver.
GB
36