Operating Instructions - Dakota Digital CRS-3000-3 Manual

OPERATING INSTRUCTIONS

XII. Dakota Digital Cruise Control OPERATING INSTRUCTIONS
ON: To operate the Cruise Control, turn the power button ON. (Green LED Indicator will light, if equipped.) Wait three
(3) seconds before setting speed.
SET SPEED: To engage system, drive at any speed above 50 KPH (33 MPH), press SET/COAST and release, then
remove your foot from the accelerator pedal. Automatic control will be at the speed of the vehicle when the button is
released plus or minus 3 KPH (1-1/2 MPH) Press accelerator and speed will increase, release accelerator and you will
return to set speed.
COAST: Press and Hold the SET/COAST button and your speed will decrease. Release button and speed of vehicle
at time button is released will be new set speed if above 50 KPH (33 MPH).
ACCEL: Press and hold the RESUME/ACCEL button and your speed will increase. Release button and you will have a
new higher set speed.
TAP-UP: You can gradually increase your speed by quickly pressing and releasing the RESUME/ACCEL button. Each
time you press and release the button your speed will increase by 1-1/2 to 5 KPH (2 to 3 MPH).
TAP-DOWN: You can gradually decrease your speed by quickly pressing and releasing the SET/COAST button. Each
time you press and release the button your speed will decrease by 11/2 to 5 KPH (2 to 3 MPH).
DISENGAGE: Depress brake pedal slightly; automatic speed control will cease but set speed will stay in the system's
memory. Also, you can disengage by pressing button to OFF position, but this erases the memory. To get the
RESUME feature to work again, you must first set a speed. Turning OFF the ignition also clears the system's
memory.
RESUME: After disengaging system with brake or clutch, return to SET speed by driving above 50 KPH (33 MPH).
Then press RESUME/ACCEL button and release it. If acceleration rate is faster or slower than you like, drive to within
a few KPH (MPH) of your set speed, then press and release the RESUME/ACCEL button.
ABOUT THE Dakota Digital Cruise Control
The performance of the Cruise Control is dependent upon the condition of the engine, its size and even by the type of
emission control equipment it has. Driving at higher altitudes will have an effect on Cruise Control's performance.
Under normal conditions and with proper switch settings, speed should be controlled within plus or minus 3 KPH (1-1/2
MPH). There may be situations; however, which make it seem as if the Cruise Control is not capable of functioning
accurately, such as an extra heavy load, a very steep hill, or a severe headwind.
CAUTION: Do not use the Cruise Control on a slippery road or in heavy traffic.
CAUTION: (Manual Transmission) While driving with the Cruise Control ON, do not shift to neutral without depressing
the clutch pedal, as this may cause engine racing or overreving. If this happens, depress the clutch pedal or turn OFF
the main Cruise Control Switch immediately.
OUR QUALIFIED EXPERT TECHNICAL SERVICE DEPARTMENT IS READY TO ASSIST YOU WITH ANY
QUESTIONS OR PROBLEMS THAT YOU MAY HAVE ABOUT OUR PRODUCT. CONTACT US VIA PHONE AT
(800) 852-3228 (USA) OR FAX AT (605) 339-4106 (USA).
4510 W. 61ST St. N., Sioux Falls, SD 57107
Phone: (605) 332-6513 FAX: (605) 339-4106
www.dakotadigital.com
dakotasupport@dakotadigital.com
© Copyright 2011 Dakota Digital Inc.
- 20 - 650014B