Dakota Digital CRS-3000-3 Manual page 10

ATTACHING CRUISE CABLE TO THROTTLE (Continued)
E. General Motors™ and Chrysler™ Throttle using THREE BEAD
CONNECTOR.
1. Most General Motors™ vehicles and many Chrysler™ vehicles can use the
THREE BEAD CONNECTOR to attach the CRUISE CABLE.
2. Attach the BEAD CHAIN to the THREE BEAD CONNECTOR. Secure beads
by folding the metal tabs.
3. Remove clip or pin which retains throttle cable (and washer if provided) and
install THREE BEAD CONNECTOR on the same side of throttle cable that the
CRUISE CABLE will be anchored (this is necessary so that CRUISE CABLE
and throttle cable will not cross).
4. The THREE BEAD CONNECTOR may need to be bent so that it clears the
throttle cable. Use the TIE STRAP (102M) to hold the THREE BEAD
CONNECTOR to the sleeve of the throttle cable.
F. General Motors™
Ford™ and Chrysler™ Throttle using STUD-CLIP W CABLE
1. Some General Motors™, Ford™ and Chrysler™ vehicles have an
attachment stud on the throttle pulley.
2. Slide a BEAD CHAIN CONNECTOR COVER over the CRUISE CABLE,
then attach the Bead CHAIN CONNECTOR to the cable.
Attach the STUD-CLIP W CABLE to the BEAD CHAIN CONNECTOR and
slide the CONNECTOR COVER over the BEAD CHAIN CONNECTOR.
3. Slide the STUD-CLIP W CABLE over the throttle pulley attachment stud. Push
the STUD-CLIP onto the vehicle stud until it snaps firmly onto the stud.
NOTE: After the CRUISE CABLE has been attached, manually move the throttle to assure the CRUISE CABLE does
not hang up on any part of the vehicle.
WARNING
Failure to follow the instruction manual could not only cause the Cruise Control to work improperly, but could cause the
throttle to hang up, possibly causing damage to your vehicle and injury and/or death to you and your passengers.
- 10 - 650014B