Advertisement
STEP 4
Set up the Hardware
To set up the QNET Mechatronic Actuators, please read the following instructions carefully. For full details, see the
QNET Mechatronic Actuators User Manual.
A
B
Place the handle on the front of the QNET
board over the bracket located on the front
of the NI ELVIS II.
24V
2.0A
External +24V
D
24V
2.0A
External +24V
E
PC
F
24V
2.0A
ELVIS +5V
User
Status
External +24V
24V
2.0A
ELVIS +5V
User
Status
External +24V
24V
2.0A
External +24V
24V
2.0A
External +24V
Ensure that the NI ELVIS II power switch
is in the OFF position.
C
Slide the PCI connector at the back of the
QNET board into the female connector on
the NI ELVIS II.
24V
2.0A
ELVIS +5V
User
Status
External +24V
Connect the NI ELVIS II power supply
24V
2.0A
to the back panel of the NI ELVIS II.
ELVIS +5V
User
Status
External +24V
ELVIS +5V
User
Status
Use the NI ELVIS II USB cable to connect
the NI ELVIS Unit to your computer.
Connect the QNET Mechatronic Actuators
power supply.
ELVIS +5V
User
Status
24V
2.0A
ELVIS +5V
User
Status
External +24V
24V
2.0A
ELVIS +5V
User
Status
External +24V
24V
2.0A
External +24V
24V
2.0A
External +24V
ELVIS +5V
User
Status
ELVIS +5V
User
Status
ELVIS +5V
User
Status
ELVIS +5V
User
Status
Advertisement
