Sony STR-DB780 Operating Instructions Manual page 44

Advanced settings (continued)
x SURROUND HGT. (
(Surround speaker height)*
Lets you specify the hight of your surround speakers
for proper implementation of the surround effects of
the Cinema Studio EX modes (page 34).
B
A
• LOW
Select if the height of your surround speakers
corresponds to section A.
• HIGH
Select if the height of your surround speakers
corresponds to section B.
* This setup item is not available when
"SURROUND" (surround speaker size) is set to
"NO".
x FRT > XXX Hz
(Front speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the front speaker bass crossover
frequency when "FRONT" (front speaker size) is set
to "SMALL". You can adjust from 40 Hz to 200 Hz
in 10 Hz steps.
x CTR > XXX Hz
(Center speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the center speaker bass crossover
frequency when "CENTER" (center speaker size) is
set to "SMALL". You can adjust from 40 Hz to
200 Hz in 10 Hz steps.
x SUR. > XXX Hz
(Surround speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the surround speaker bass crossover
frequency when "SURROUND" (surround speaker
size) is set to "SMALL". You can adjust from 40 Hz
to 200 Hz in 10 Hz steps.
GB
44
)
SL SR
B
60
A
30
x L.F.E. > XXX Hz
(LFE high cut filter)
Initial setting: STD (120 Hz)
Lets you select the cut off frequency of the LFE
channel high cut filter. Normally, select "STD
(120 Hz)".
When using a passive sub woofer powered by a
separate power amplifier, it may be better to change
the cut off frequency. In this case, you can adjust
from 40 Hz to 200 Hz in 10 Hz steps.
Advanced SURROUND menu
parameters
When "MENU" is set to "MENU EXP.", all of
the following parameters are displayed and
adjustable.
See page 37 for the SURROUND menu
adjustments.
Initial settings are underlined.
All SURROUND menu parameters
C.WIDTH X*
DIMEN. X*
PANO.*
EFFECT XX
WALL XXX*
REVB. XXX*
SCR.*
* Adjustable only when "MENU" is set to "MENU
EXP.".
x C WIDTH X
(Center width control)
Initial setting: 3
Lets you perform further adjustments for Dolby Pro
Logic II Music mode decoding (PLII MUSIC). You
can set this parameter only when "2CH MODE" is set
to "PLII MUSIC" (page 36) and NORMAL
SURROUND is selected.
You can adjust the distribution of the center channel
signal, generated through the Dolby Pro Logic II
decoding, to the L/R speakers. C WIDTH is
adjustable in 8 steps from "0" (no spread) to "7" (full
phantom).