Rev Pong - IK Multimedia AmpliTube X-TIME User Manual

AmpliTube X-TIME

REV PONG

This is an advanced ping pong delay effect. The delay sound is sent to a reverb that can be modulated. Also,
the second tap of the ping pong pattern can be reversed to really get a very custom sound.
Parameters
• TIME: controls the time of the delay repetitions.
From 60 ms to 2000 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the frequency response of the delay. Turn it counterclockwise to get darker tones or
clockwise for brighter sounds.
From 0 to 10.
• MOD: controls the depth of the LFO happening on the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• REVERB: controls the mix for the reverb applied to the delay.
From 0% to 100%.
• REVERSE: reverses the one of the two taps of the ping pong effect.
ON or OFF.
• LFO RATE: controls the rate of the LFO applied to the delay.
From 0.5 Hz to 10 Hz.
• X-MODE: the X-MODE pushes the feedback to infinity.
ON or OFF.
REV PONG Control Changes
Parameter
TIME
FEEDBACK
FILTER
MOD
MIX
REVERB
REVERSE
LFO RATE
X-MODE
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
21
Control Change #
21
22
23
24
25
46
47
48
13
Values
0 – 127
0 – 127
0 – 127
0 – 127
0 - 127
0 – 127
0 - 127
0 - 127
0 - 127
Delay Models