Press RM SET UP.
The RM SET UP button flashes.
Press 1 or 2 while the RM SET UP
button is flashing.
When you press 1, the command mode is
set to AV SYSTEM 1. When you press 2,
the command mode is set to AV SYSTEM
Press ENTER when the RM SET UP
button lights up.
The RM SET UP button flashes twice, then
the command mode setting process is
When you press RM SET UP, use a thin wire, such
as a paper clip.
To switch the command mode
of the RM-AAU018 remote
Press and hold DISPLAY, then press
at the same time.
7: Operating the receiver
using the GUI
You can change the display mode of the menu
to the screen mode using the following
procedures. "GUI MODE" appears in the
display window in the screen mode.
By using the GUI menu, you can make various
settings and adjustments.
Refer to "Operating without connecting to the
TV" (page 95) if you are not going to use a
Displaying the GUI menu on the
Connect a TV monitor to this
Refer to "3: Connecting the monitor"