Table of Contents
Advertisement
Fault
The appliance does
not switch off fully at
the end of a cooking
time.
The time flashes in
the display.
lights up in
the display and no
settings can be made
on the appliance.
A message with ap-
pears in the display,
e.g.
-
.
Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance gets very hot.
▶ Never touch the inside surfaces of the cooking
compartment or the heating elements while they
are hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
WARNING ‒ Risk of electric shock!
When replacing the cooking compartment
bulb, be aware that the bulb socket contacts
are live.
▶ Before replacing the bulb, unplug the appliance
from the mains or switch off the circuit breaker in
the fuse box.
Cause and troubleshooting
At the end of a cooking time, the appliance stops heating up. The oven light and cooling fan
do not switch off. For types of heating with air recirculation, the fan continues to run in the
back wall of the cooking compartment.
Turn the function selector to the off position.
▶
a The appliance is switched off.
a The oven light and the fan in the back wall are switched off.
a The cooling fan switches off automatically as soon as the appliance has cooled down.
There has been a power cut.
Reset the time.
▶
→ "Setting the time", Page 10
Childproof lock is activated.
Use
to deactivate childproof lock.
▶
→ "Childproof lock", Page 10
Electronics fault
Press .
1.
If necessary, reset the time on the clock.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. State the exact error
2.
message and the E no. for your appliance in full.
→ "Customer Service", Page 16
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it.
2.
Pull out the halogen bulb without turning it.
3.
Insert the new halogen bulb and press it firmly into
4.
the socket.
Make sure the pins are positioned correctly.
Depending on the appliance model, the glass cover
5.
may have a sealing ring. Attach the sealing ring.
Screw in the glass cover.
6.
Remove the tea towel from the cooking compart-
7.
ment.
Connect the appliance to the power supply.
8.
Troubleshooting en
15
Advertisement
Table of Contents
